This installation is for a N Scale MiniTrix FM Switcher using a TCS Z2 decoder and was performed by Daniel Thomson.
Decoder install documented by TCS.
Note: This installation requires milling to fit the Z2 above the motor in the chassis. Minor mods to the light bezels for LED lighting was also required.
Additional upgrades to this model: Remotored with Northwest Short Lines 10203-9 Can Motor.
Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.
TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.
When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire