Hornby 2-6-4 Stanier 4MT Class 4P

Scale:
HO Scale


This installation uses the following decoder:


TCS DP2X-UK Decoder Installation for HO-Scale Hornby 2-6-4 Stanier 4MT Class 4P locomotive. It was performed by a TCS customer.

When installing the DP2X-UK in this locomotive the four wires around the NMRA socket must be moved to the front and back side of the decoder to prevent them from blocking the shell from sliding down either side of the frame. As demonstrated below we ran two wires around the back side, and two around the front and the decoder fit wonderfully.
When installing the DP2X-UK in this locomotive the four wires around the NMRA socket must be moved to the front and back side of the decoder to prevent them from blocking the shell from sliding down either side of the frame. As demonstrated below we ran two wires around the back side, and two around the front and the decoder fit wonderfully.





Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire