Life Like Proto 2000 GP38-2

Scale:
HO Scale


WOWKit used in this installation

WDK-LIF-3

Which includes the following items:

Decoder
Motherboard
Speaker Kit


DXI Installation

This was performed by our friends from DCC Xpress installations. 
They offer high quality WOWSound installations for a flat rate complete with free return shipping! 
You can find them at: www.dxinstalls.com

This installation is for a HO Scale Proto 2000 GP38-2.

With milling of the frame, they have been able to utilize a 
IB-MB1 motherboard, WOW121 diesel decoder and UNIV-SH4C WOWSound kit installation for the single front and rear bulb version.

HO-Scale Life Like Proto 2000 GP38-2 shown prior to installation.
HO-Scale Life Like Proto 2000 GP38-2 shown prior to installation.






Shown with installation complete.
Shown with installation complete.



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.

TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.

You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire