The installation is for HO-Scale Hobbytown Baby Trainmaster. It uses T1 decoder and was performed by Jean Lacroix.
This model is a Hobbytown of Boston drive with a metal body shell from Bowser. On this model, the body is attached with screws located underneath the locomotive in the middle of it. Just removing the screws let the body free.
All the wires connected to the motor should be removed from it. The motor has to be unscrewed from its location since it would create an electrical short in dcc mode. To prevent that, install on the floor of the locomotive, where the motor was, a rubber pad or a piece of plastic large enough to isolate the motor from the frame.
The motor should be glued in place using goo or silicone, taking care to avoid any moving parts. Pay special attention to align the drive shaft and the motor sprocket. Once you have soldered the wires on the motor terminals, add electrical tape over them in order to avoid contact with metal body that could create short circuit. You can use heat shrink tubing over each wires that are soldered together.
The orange and grey wire from the T1 harness should be soldered to the terminals located on both side of the motor.
Then connect the red wire to the top of the front truck and the black wire should be attached or soldered to the rear truck.
It is a good idea to add contact wires made of phosphor bronze, inserted in plastic tubing, on the side of truck that has insulated wheels.
The decoder can be installed on a plastic shelve sitting on top of the driveshaft or on the ceiling of the locomotive body using double sided tape.
Important Soldering Tip
Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.
TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.
You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775
Other solder tips
When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire