This installation documentation is for a N-scale Boxcar manufactured by Bachmann. This installation was performed using a TCS WOW101 Diesel Decoder, KA3 Keep Alive® and 25x14mm WOWSpeaker.
Note: This installation can be performed using either a WOW101-KA-Steam or WOW101-KA-Diesel decoder, based on which type of locomotive you wish to use with the car. This conversion is popular for diesels which do not have large open spaces like the tenders in steam.
N Scale Bachmann Boxcar shown prior to installation.
Gently pulling outwards at each end and along each side of the frame to lift the shell off of the frame.
The Bachmann Boxcar shown with the shell off. Trim off the tops of these two posts to allow removal of the weight.
To allow space for the new components, trim the top half of these two ribs on either side flush with the interior sides.
The frame shown prepared for the speaker installation step.
Using a small bit, drill several holes in the center of the frame platform for the speaker sounds to escape.
Using four small, triangular pieces of double sided foam tape, mount the 20mm WOWSound speaker onto the frame as shown.
Taking the wiring harness from the WOW101 decoder, splice in the wires from the micro connectors to match the colors. The other end of this harness needs to be wired to your locomtoive's motor, track power pickups, and lights.
Cut a small hole in the front of the frame platform as shown above to allow the wire leads a path out.
Using double-sided foam tape, mount the WOW101 Diesel decoder and KA3 Keep Alive® onto the top inside of the shell.
Now you can close up the boxcar. Be sure to be mindful of wire routing and reassembly of the shell as to not damage or foul the installation. Your Bachmann Boxcar is now WOWSound equipped and ready to roll!
Important Soldering Tip
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
Other solder tips
When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire