Roco DSB ML 6 Switcher

Scale:
HO Scale


This installation uses the following decoder:


This installation documentation is for the HO Scale Roco DSB ML 6. This installation uses the M1P-1" decoder, and was performed by John McCluskey of New York State.

The picture above shows the locomotive prior to the decoder installation.
The picture above shows the locomotive prior to the decoder installation.


Disassemble locomotive as per enclosed directions. Remove interior cab shroud, then carefully remove the DCC "dummy" plug.
Disassemble locomotive as per enclosed directions. Remove interior cab shroud, then carefully remove the DCC "dummy" plug.


Plug in the decoder so that the Orange wire lines up with Pin #1 of the socket. Pin #1 will be designated with a "1" or a small arrow/chevron.
Plug in the decoder so that the Orange wire lines up with Pin #1 of the socket. Pin #1 will be designated with a "1" or a small arrow/chevron.


Carefully install the M1P-SH Reinstall the cab shroud, tucking the wires neatly inside. Finally, re-install the shell.
Carefully install the M1P-SH Reinstall the cab shroud, tucking the wires neatly inside. Finally, re-install the shell.



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.

TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.

You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire