Tilling SM26

Scale:
TT Scale


This installation uses the following decoder:

MC2



TCS MC2 Decoder Installation for TT-Scale Tilling SM26. It was performed by Krzysztof Brocki – Poland.

The SM26 Tillig locomotive in TT scale sale as a starter set. This locomotive doesn’t have lights and DCC socket.
The SM26 Tillig locomotive in TT scale sale as a starter set. This locomotive doesn’t have lights and DCC socket.


The SM26 is a small locomotive a special in TT scale but there is enough place for TCS MC2 decoder.
The SM26 is a small locomotive a special in TT scale but there is enough place for TCS MC2 decoder.




The capacitor (blue one) and wires from wheel to motor was removed.
The capacitor (blue one) and wires from wheel to motor was removed.




The wires were soldered as shown in the photo above. Gray and orange to the motor, red and black to the wheel.
The wires were soldered as shown in the photo above. Gray and orange to the motor, red and black to the wheel.


Decoder was placed on the top of motor. The wires for lights were not used, but I will made lights in the future.
Decoder was placed on the top of motor. The wires for lights were not used, but I will made lights in the future.


It's finished. The decoder is visible through the cabin window.
It's finished. The decoder is visible through the cabin window.



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire