Life Like RS2

Scale:
N Scale


This installation uses the following decoder:


This installation is for N Scale LifeLike RS 2 uses TCS K2D4 Decoder and was performed by A.G.

The upper picture shows the Life Like RS2 with its shell on.
The upper picture shows the Life Like RS2 with its shell on.


This picture shows the locomotive's chassis with its shell taken off and the original lighting board. Be careful as you take off the shell because it is difficult to remove and can be broken easily.
This picture shows the locomotive's chassis with its shell taken off and the original lighting board. Be careful as you take off the shell because it is difficult to remove and can be broken easily.


Wrap kapton tape over the frame above the motor contacts as well as the protrusion of metal shown on the right in the image above. This is application of tape is crucial to ensure that the decoder and LED leads do not short against the frame.
Wrap kapton tape over the frame above the motor contacts as well as the protrusion of metal shown on the right in the image above. This is application of tape is crucial to ensure that the decoder and LED leads do not short against the frame.


This is a picture of the fully installed board. All in all it is not a very difficult installation. If you, for any reason, need to remove the K2D4, it will have a tendency to get hung up on the front LED, so you will have to lift this LED over the hump in the locomotive frame.
This is a picture of the fully installed board. All in all it is not a very difficult installation. If you, for any reason, need to remove the K2D4, it will have a tendency to get hung up on the front LED, so you will have to lift this LED over the hump in the locomotive frame.



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire