Life Like GP60

Scale:
N Scale


This installation uses the following decoder:


This installation is for the N Scale Life-Like GP60 uses a TCS L1D4 Decoder and was performed by TCS.

First remove the shell by rocking it from the front to the back until it slips off the frame.
First remove the shell by rocking it from the front to the back until it slips off the frame.


Now you should be presented with a chassis and lighting board as seen above. Next, slide the lighting board towards the back of the chassis and then lift it up and out.

With the lighting board removed the chassis should look like the image below.
Now you should be presented with a chassis and lighting board as seen above. Next, slide the lighting board towards the back of the chassis and then lift it up and out. With the lighting board removed the chassis should look like the image below.


Taking care to cover the motor tabs (as highlighted above in red) on either side of the frame with the phosphor-bronze legs of the decoder, place the decoder in the frame and slide it forward.

The chassis with the decoder installed should look like the image below.
Taking care to cover the motor tabs (as highlighted above in red) on either side of the frame with the phosphor-bronze legs of the decoder, place the decoder in the frame and slide it forward. The chassis with the decoder installed should look like the image below.


Now replace the shell and you are ready to run!
Now replace the shell and you are ready to run!



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire