Kato GE C44-9W

Scale:
N Scale


This installation uses the following decoder:


This installation is for N Scale Kato GE C44-9W uses TCS K1D4 Decoder and was performed by TCS.





The three pictures above show the Kato GE C44-9W with the shell on.
The three pictures above show the Kato GE C44-9W with the shell on.


This is a picture of the frame with the shell removed and the original lighting board installed.
This is a picture of the frame with the shell removed and the original lighting board installed.


After removing the original lighting board, apply Kapton tape to the area of the frame between the motor tabs so that the frame is isolated from the motor clips on the decoder.
After removing the original lighting board, apply Kapton tape to the area of the frame between the motor tabs so that the frame is isolated from the motor clips on the decoder.


Line up the tabs from the motor with the motor clips that are on the decoder.
Line up the tabs from the motor with the motor clips that are on the decoder.


This is a picture of the fully installed K1D4. This is an easy drop-in installation.
This is a picture of the fully installed K1D4. This is an easy drop-in installation.



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire