Intermountain FP7

Scale:
N Scale


This installation uses the following decoder:


Intermountain FP7 with TCS IMFP4 Decoder. Installed by TCS.

First remove the screw highlighted in the image below and remove the front coupler from the locomotive.
First remove the screw highlighted in the image below and remove the front coupler from the locomotive.


Next, desolder the LED wires from the lighting board and then unscrew and remove the original lighting board.
Next, desolder the LED wires from the lighting board and then unscrew and remove the original lighting board.


Now screw the IMFP4 in were the lighting board used to be. Solder the LED wires to the IMFP4 as shown in the image below.
Now screw the IMFP4 in were the lighting board used to be. Solder the LED wires to the IMFP4 as shown in the image below.


Replace the shell on the locomotive, reattach the coupler to the locomotive and you are ready to run.
Replace the shell on the locomotive, reattach the coupler to the locomotive and you are ready to run.



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire