Bachmann Bachfar 08

Scale:
N Scale


This installation uses the following decoder:

M1



TCS M1 Decoder Installation for N-Scale Bachmann Bachfar 08 locomotive.

Photos by John Gray of Westbury, Wiltshire, England.

These locos have to have the lower brush holders modified, I obtain the kits to carry out this delicate operation from Gerry Spencer.
These locos have to have the lower brush holders modified, I obtain the kits to carry out this delicate operation from Gerry Spencer.







Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire