Atlas MP15

Scale:
N Scale


This installation uses the following decoder:


This installation is for N Scale Atlas MP15 and uses TCS MP-15N Decoder and was performed by TCS.

First, remove the shell by pinching it on either side and rocking it back and forth until it slides off.
First, remove the shell by pinching it on either side and rocking it back and forth until it slides off.


Next loosen the two frame screws until the original lighting board can be lifted out.
Next loosen the two frame screws until the original lighting board can be lifted out.


NOTE: In some locomotives it is necessary to trim back the motor pickups to reduce the risk of incidental contact. Highlighted above in red you can see the motor tabs post trimming.
NOTE: In some locomotives it is necessary to trim back the motor pickups to reduce the risk of incidental contact. Highlighted above in red you can see the motor tabs post trimming.


NOTE: In some locomotives it is necessary to trim back the motor pickups to reduce the risk of incidental contact. Highlighted above in red you can see the motor tabs post trimming.
NOTE: In some locomotives it is necessary to trim back the motor pickups to reduce the risk of incidental contact. Highlighted above in red you can see the motor tabs post trimming.


Lastly, install the MP-15N decoder with the same orientation as the original lighting board.

Replace the shell and you are ready to run your locomotive!
Lastly, install the MP-15N decoder with the same orientation as the original lighting board. Replace the shell and you are ready to run your locomotive!



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire