Atlas GP9

Scale:
N Scale


This installation uses the following decoder:


This installation is for N-Scale Atlas GP9 uses TCS CN-GP decoder and was performed by TCS.

The CN-GP is a wonderful fit for the GP9. Simply follow the directions in the Classic N installation guide and enjoy your reclaimed locomotive!



With a CN-GP installed.

After installing the CN-GP with TCS exclusive auto-adjusting BEMF in the GP9 we enjoyed extremely slow speeds, and surprisingly realistic motor control.
With a CN-GP installed. After installing the CN-GP with TCS exclusive auto-adjusting BEMF in the GP9 we enjoyed extremely slow speeds, and surprisingly realistic motor control.



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire