Broadway Limited Blue Line USRA Light Mikado 2-8-2

Scale:
HO Scale


This installation uses the following decoder:


The installation is for HO-Scale Broadway Limited Blue Line USRA Light Mikado 2-8-2. It uses MC2P-SH decoder and was performed by A.G.

TCS recommends using the DP2X decoder for simple plug-and-play installation.





The three pictures above show the locomotive prior to the decoder installation.
The three pictures above show the locomotive prior to the decoder installation.


The locomotive came to us sound equipped with 8 PIN NMRA socket for motor/light decoder installation. The decoder will be installed in the tender.
The locomotive came to us sound equipped with 8 PIN NMRA socket for motor/light decoder installation. The decoder will be installed in the tender.


Remove the tender's shell by lifting it up and off the chassis.
Remove the tender's shell by lifting it up and off the chassis.


Disconnect two sound decoder plugs so that you can easily access the 8 Pin NMRA plug.
Disconnect two sound decoder plugs so that you can easily access the 8 Pin NMRA plug.


Remove the 8-pin "dummy" plug.
Remove the 8-pin "dummy" plug.


Plug in the decoder so that the Orange wire lines up with Pin #1 of the socket. Pin #1 will be designated with a "1" or a small arrow/chevron.
Plug in the decoder so that the Orange wire lines up with Pin #1 of the socket. Pin #1 will be designated with a "1" or a small arrow/chevron.



Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use. 
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157
http://www.techni-tool.com

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire