TCS T1 Decoder with E6 harness for HO Scale LifeLike Proto 2000 E6. Performed by J.M. The E6 harness is available through TCS dealers or direct from TCS. The E6 harness is sold separately from the T1 decoder. The E6 harness SKU number is 1037.

Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157


The picture above shows the beautiful LifeLike Proto 2000 E6 with its shell on.

Lift the shell off starting at the back and gently slide it forward past the front coupler before lifting it completely off. Above photo shows shell removed.

Remove the dummy plug highlighted above.

Photo above shows close up of E6 harness plugged into the loco light board. Notice the solder bridge connecting the yellow and green wires. The E6 harness comes with this solder jumper applied. This is to accommodate the control of the Mars light. Change the following CV's. Make CV50=0(on when forward), make CV34=4(re maps yellow wire to button 1 control). Then use headlight button to turn on the headlight and button one to turn on the Mars light.

Photo below shows completed T1 decoder with E6 harness installation. Notice the E6 harness is made a specific length to fit the loco. We advise adding a piece of kapton tape over the decoder to prevent bouncing and shaking during use. Replace the shell by first sliding it over the front coupler and then lowering the rear of the shell until it fits snuggly. Your locomotive is ready to run!

Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Entire contents © Copyright Train Control Systems 2004-2018