This installation of TCS LL8 Decoder is for HO Scale LifeLike Proto 2000 Heritage USRA 0-6-0 and was performed by A.G.

Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

The three upper pictures show the beautiful Lifelike Proto 2000 Heritage USRA 0-6-0 with its shell on prior to the LL8 Decoder installation.


Locomotive's tender close-up picture. The decoder will be installed here.


Here is a picture of the tender's bottom. Four phillips screws need to be removed. See two pictures below for details.


Remove the two rear phillips screws that are marked in red.


Remove the two front phillips screws that are circled in red.


Gently, remove the tender's shell. The picture above shows the original light board.


Lift the dummy plug off of the original light board exactly as shown in the picture above.


Here we installed the TCS LL8 decoder using the original screws. Then we flipped the NMRA socket so that Pin#1 of the decoder is lined up with the orange wire of the NMRA socket.


Here is the picture of the TCS LL8 decoder installed in the locomotive's tender.Locomotive is ready to run!

Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Entire contents © Copyright Train Control Systems 2004-2018