The installation is for HO-Scale Broadway Limited Blue Line RSD15. It uses TCS MC2P-SH decoder and was performed by a TCS Customer

Important Soldering Tip:
Please do not use any flux either liquid or paste on the mother board. It will damage it. Use only Rosin core solder approved for electronics use.
We recommend to use only Kester "44" rosin core, SN63PB37, .015" diameter, part number 24-6337-0007.
This can be ordered from Techni-Tool under Techni-Tool part number 488SO157

There are several good options for installing a TCS decoder in this Blue Line SD40-2 locomotive.   The MC2P-SH is the most simple and straight forward, it plugs directly into the 8 pin NMRA socket supplied with the locomotive. The T1 decoder with a short length harness, or the M1P-SH decoder with a short length harness will also work just fine. Unfortunately the DP2X does not fit  because one of the board mounted connectors fouls the area.


Other solder tips: When stripping wire, only strip a tiny little bit of the insulation. Strip no more then a 1/64 of an inch. When the wire gets tinned with solder the insulation will shrink back more. Try to not expose any more wire then half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire

Like us on Facebook Subscribe to our YouTube Channel Join our newsletter
  Back To Top
Entire contents © Copyright Train Control Systems 2004-2018